WARP cables keep cool cable


The test shows that the Cat.6A U/UTP WARP cables developed by R&M dissipate heat more effectively than conventional unshielded cables. ‘WARP cables stay cool and behave just as well as shielded cables. That is an advantage when you are planning a local data network intended to include Power over Ethernet,’ explained Matthias Gerber, market manager LAN Cabling at R&M. In big installations with massive cable bundles and PoE operation, a WARP cable becomes less hot than conventional unshielded U/UTP cables and the link is therefore allowed to be correspondingly longer.

Power over Ethernet (PoE) – that is, supplying power to terminal equipment over data cables – is increasingly popular. The advantages of using PoE are obvious: The power supplied to the device does not have to be separately fed over a power cable and an unwieldy power supply unit or from a battery. Instead, the device draws its energy over the data network. To this end, current has to be fed into the data line in addition to the data signal at a central point, namely in the network distributor.

IEEE, the standards organization, is currently working on markedly increasing the transmittable power supplied. The new 4PPoE protocol will make available two new levels of power: 55 W (level 3) and 90 to 100 W (level 4). Up to one ampere is supposed to flow over each twisted pair. This approach opens up new applications such as the operation of high-powered WLAN antennas and monitoring cameras. However, the higher current level poses new challenges for data cabling.

Wherever more current is flowing, there will be more heat due to resistance. Warmer cables attenuate data transmission to a greater extent than before. As a result, there may not be enough signal reaching the receiver, thereby making data transmission impossible. This effect must be taken into account when new PoE-compatible LAN cabling is planned. The maximum transmission distance must be adjusted to temperature conditions and shortened.

Shielding helps dissipate heat from cable bundles
The relevant draft standards ISO/IEC TR 29125 and Cenelec EN 50174-99-1 already describe the cable bundle temperature rise to be expected from the use of 4PPoE. A distinction is made between two heat fractions:
• A bundle heating up from the inside to the outside
• The entire cable bundle heating up from the outside up to the ambient temperature.

The second fraction depends largely on the installation conditions of the cable bundle. The first, the temperature rise within the cable, depends solely on how the cable is constructed. In a typical U/UTP cable, the PoE-related heat-up rises by a factor of 5 whereas in a shielded cable it ranges from a factor of 2.5 to 3 depending on the design.

That means in a cable bundle consisting of U/UTP cables, the temperature rises by 2 times as much as in a comparable bundle consisting of S/FTP cables. The reason is that in shielded cables the metal in the shield helps to transport the heat from within the bundle to the outside.

  • Show Comments

Your email address will not be published. Required fields are marked *

comment *

  • name *

  • email *

  • website *